Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the SIR system.
Refer to
Disabling the SIR System
in SIR.
- Disconnect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine
Electrical.
- Remove the IP retainer. Refer to
Instrument Panel Retainer Replacement
.
- Remove the data link connector fasteners.
- Remove the passenger inflator module. Refer to
Inflatable Restraint Instrument Panel Module Replacement
in SIR.
- Disconnect the ignition switch electrical connectors.
- Remove the shift/park lock cable from the ignition switch.
- Disconnect the body to
IP electrical connector (1) located at the upper right outside corner
of the IP carrier.
- Remove the HVAC aspirator
tube (5).
- Feed the ignition switch wiring (4) through the IP carrier.
- Feed the shift/park lock cable (3) through the IP carrier.
- Feed the console wiring harness (1) through the IP carrier.
- Release the SIR harness (6) retainer from the IP carrier.
- Remove the IP carrier
fasteners.
- Remove the IP carrier from the vehicle.
Installation Procedure
- Align the instrument panel
(IP) carrier to the vehicle.
- Install the HVAC aspirator tube (5).
- Feed the ignition switch wiring (4) through the IP carrier.
- Feed the shift/park lock cable (3) through the IP carrier.
- Feed the console wiring harness (1) through the IP carrier.
- Install the SIR harness (6) retainer to the IP carrier.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the fasteners (1)
from the IP carrier to hinge pillar.
Tighten
Tighten the IP carrier fasteners (1) to 25 N·m (18 lb ft).
- Install the IP carrier to cowl fasteners (2).
Tighten
Tighten the carrier to cowl fasteners (2) to 25 N·m
(18 lb ft).
- Install the IP carrier to end bracket fasteners (3).
Tighten
Tighten the carrier to end bracket fasteners (3) to 25 N·m
(18 lb ft).
- Connect the ignition switch electrical connectors .
- Install the shift/park lock cable to the ignition switch.
- Install the passenger inflator module. Refer to in SIR.
- Install the data link connector fasteners.
Tighten
Tighten the fasteners to 2 N·m (18 lb in).
- Install the IP retainer. Refer to
Instrument Panel Retainer Replacement
.
- Connect the negative battery cable. Refer to
Battery Negative Cable Disconnection and Connection
in Engine
Electrical.
- Enable the SIR system. Refer to
Enabling the SIR System
in SIR.