SDM Reprogram - Class Action Settlement (U.S. Only). Oldsmobile Cutlass 1999

Subject:

SDM Reprogram - Class Action Settlement (U.S. Only)

Models:

1997-1999 Chevrolet Malibu

1997-1999 Oldsmobile Cutlass

PURPOSE

The purpose of this bulletin is to provide GM Dealers with information about Class Action Settlement CJ-2002-424 for certain 1997, 1998 and 1999 Chevrolet Malibu and certain 1997, 1998 and 1999 Oldsmobile Cutlass vehicles. As part of the settlement, GM has agreed to reprogram the air bag sensing and diagnostic module (SDM) at no cost to the customer. Reprogram the SDM in these vehicles if the customer presents a copy of the letter included on page 3 of this bulletin. Retain a copy of the customer letter with the CSO. Claims for 1997 and 1998 vehicles need to be H-routed through your ASM for payment approval before submitting a claim. Use the labor operation number and time published in this bulletin to receive payment. The labor operation number in this bulletin is for bulletin use only. It will not be published in the Labor Time Guide.

SERVICE PROCEDURE

Important: The Tech 2 diagnostic tool must be updated with version 27.004 or later for reprogramming the air bag sensing and diagnostic module (SDM).

Turn the ignition switch to the "ON" position and verify that the "AIR BAG" warning lamp flashes seven (7) times and then turns "OFF".
If the "AIR BAG" warning lamp does not operate as described, perform the SIR diagnostic system check as described in the appropriate service manual before proceeding.
Connect the Tech 2 to the vehicle's data link connector (DLC) under the instrument panel.
Turn the Tech 2 "ON" by pressing the power button.
Press "ENTER" to access the "MAIN MENU".
Use the "UP" and "DOWN" buttons (arrows) on the Tech 2 to move the highlight bar to the selections described in the following steps.
Select "DIAGNOSTICS" on the "MAIN MENU" screen and press "ENTER".
Select the appropriate model year (1997, 1998, or 1999) on the "VEHICLE IDENTIFICATION" (model years) screen and then press "ENTER".
Select "PASSENGER CAR" on the "VEHICLE IDENTIFICATION" (vehicle types) screen and press "ENTER".
Select "BODY" on the "SYSTEM SELECTION MENU" screen and then press "ENTER".
Select the letter "N" on the "VEHICLE IDENTIFICATION" (car product lines) screen and press "ENTER".
Select the appropriate GM nameplate (Chevrolet or Oldsmobile) on the "VEHICLE IDENTIFICATION" (nameplate) screen and press "ENTER".

•	· For 1997-1998 Chevrolet select the appropriate vehicle series (Malibu or NE Malibu LS) on the vehicle series screen and press "ENTER".

•	· For 1999 Chevrolet select the appropriate vehicle series Malibu on the vehicle series screen and press "ENTER".

•	· For 1997-1999 Oldsmobile select the appropriate vehicle series (NB Cutlass or NG Cutlass GLS) on the vehicle series screen and press "ENTER".

Select "SUPPLEMENTAL INFLATABLE RESTRAINT" on the "BODY" screen and press "ENTER".
Confirm that the ignition switch is still in the "ON" position (engine not running).
Select "SPECIAL FUNCTIONS" on the "SUPPLEMENTAL INFLATABLE RESTRAINT" screen and press "ENTER".
Select "SDM REPROGRAMMING" on the "SPECIAL FUNCTIONS" screen and press "ENTER".
Follow the on screen instructions.

Important: If the vehicle has previously had the SDM replaced with an updated version, the Tech-2 will display: "procedure not required".

After reprogramming is complete, turn the ignition switch to "OFF" and disconnect the Tech 2 from the vehicle's DLC.
Turn the ignition switch to "ON" and verify that the "AIR BAG" warning lamp flashes seven (7) times and then turns "OFF". If it does not operate as described, perform the SIR diagnostic system check as described in the appropriate service manual.

Warranty Information

Labor Operation	Description	Labor Time
Y0147	Reprogram SDM	0.2

FINAL NOTICE OF APPROVAL OF SETTLEMENT
NAME: ADDRESS: VEHICLE IDENTIFICATION NUMBER: In _____________ 2006, you were notified of a proposed settlement of a lawsuit styled, Delmas Ford, et al. v. General Motors Corporation, Case No. CJ-2002-424, pending in the District Court of Bryan County, Oklahoma. On__________, 2006, the Court held a Fairness Hearing to determine whether to approve the settlement as fair, reasonable and adequate. At the hearing, the Court approved the proposed Settlement Agreement and entered a Final Judgment, which has become final and no longer subject to appeal. The purpose of this Final Notice is to inform you that the Settlement Agreement has been approved and that you now have the opportunity to receive the benefit agreed upon and approved by the Court. You may present the vehicle with the above Vehicle Identification Number to an Authorized Chevrolet Dealer in order to have the vehicle's Sensing and Diagnostic Module reprogrammed. You must present the vehicle before {Date} to obtain the reprogramming. Please take this notice with you to show the service personnel at the Authorized Chevrolet Dealer.

FINAL NOTICE OF APPROVAL OF SETTLEMENT

NAME:

ADDRESS:

VEHICLE IDENTIFICATION NUMBER:

In _____________ 2006, you were notified of a proposed settlement of a lawsuit styled, Delmas Ford, et al. v. General Motors Corporation, Case No. CJ-2002-424, pending in the District Court of Bryan County, Oklahoma. On__________, 2006, the Court held a Fairness Hearing to determine whether to approve the settlement as fair, reasonable and adequate. At the hearing, the Court approved the proposed Settlement Agreement and entered a Final Judgment, which has become final and no longer subject to appeal.

The purpose of this Final Notice is to inform you that the Settlement Agreement has been approved and that you now have the opportunity to receive the benefit agreed upon and approved by the Court. You may present the vehicle with the above Vehicle Identification Number to an Authorized Chevrolet Dealer in order to have the vehicle's Sensing and Diagnostic Module reprogrammed. You must present the vehicle before {Date} to obtain the reprogramming. Please take this notice with you to show the service personnel at the Authorized Chevrolet Dealer.