Tools Required

1. Engine Mounts are the non-adjustable type and seldom require service. Broken or deteriorated mounts should be replaced immediately, because of the added strain placed on the other mounts and the driveline components.
2. Raise the engine in order to remove the weight from the mounts and in order to place a slight tension on the rubber. Observe both mounts while raising the engine.
3. Replace a powertrain mount if it exhibits one of the following conditions:

•	Hard rubber surface covered with heat cracks

•	Rubber separated from the metal plate of the mount

•	Rubber split through the center

•	Fluid leaking from hydraulic mounts

1. Remove the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

   in General Information.



2. Remove the engine mount retaining nuts from the frame mounting bracket
3. Raise the engine in order to provide clearance. Use the J 28467-360 , the J 35953 , and the J 28467-90 .
4. Remove the drip shield.
5. Remove the oil filter.
6. Remove the engine mount bracket from the engine.



7. Remove the engine mount from the bracket.

Tools Required

1. Install the engine mount to the mount bracket.
2. Install the nuts connecting the engine mount to the bracket.

Tighten
Tighten the nuts to 47 N·m (35 lb ft).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.




3. Install the bracket to the engine.
4. Install the bolts connecting the engine mount bracket to the engine.

Tighten
Tighten the bolts to 102 N·m (75 lb ft).

5. Install the oil filter.
6. Install the drip shield.
7. Lower the vehicle.
8. Remove the J 28467-360 , the J 35953 , and the J 28467-90 .
9. Install the engine mount retaining nuts.

Tighten
Tighten the nuts to 43 N·m (32 lb ft).

10. Connect the negative battery cable.