Evaporative Emission Canister Replacement Oldsmobile Only

1. Remove the left rear wheelhouse liner.
2. Remove the hoses from the canister. Mark the hoses to install on the new canister.
3. Loosen the latch on the canister bracket. Position out of the way.
4. Remove the canister from the vehicle.

1. Install the canister to the vehicle.
2. Install the hoses to the canister as noted during removal.
3. Position the latch on the canister bracket.
4. Fasten securely.
5. Install the wheel house liner.

Evaporative Emission Canister Replacement Chevrolet Only

1. Disconnect the negative battery cable.
2. Raise the vehicle.
3. Remove the driver side rear wheel and housing liner.
4. Remove the hoses from canister. Mark the hoses to ensure correct installation on new canister.

Important: Inspect the canister hoses for damage or deterioration. Refer toEmission Hose Routing Diagram for proper routing of canister hoses. When replacing the lines, use the correct replacement part.

5. Remove the canister and latch assembly from the canister bracket.
6. Release the latch securing the canister.
7. Remove the canister.

1. Install the canister and engage the latch assembly.
2. Install the canister and latch assembly to the canister bracket.
3. Install the hoses to canister. Make sure the connections are correct.
4. Install the driver side housing liner and wheel assembly.

Tighten
Torque the wheel nuts to 140 N·m (104 lb ft).

5. Lower the vehicle
6. Reconnect the negative battery cable.