A/C DISCHARGE LINE BREAKAGE AND/OR REPEAT FAILURE (NEW PART) - 1986-88 NINETY-EIGHT AND EIGHTY-EIGHT WITH 3.8L ENGINES (VIN CODE B OR 3) (Section No. 1B)
If a repeat failure or cracking of the A/C discharge pipe at the rear of the compressor is encountered on the subject vehicle, install kit 25537148 and follow instructions below:
1. Replace hose.
2. Torque all compressor to mount bolts to 55 N.m. (37 lbs. ft.)
3. Remove and clean indicated #50 Torx head bolt. Add Loctite 271 or equivalent to #50 Torx head bolt, reinstall and torque to 55 N.m (37 lbs. ft.)
4. Add Loctite 271 or equivalent to bolt/screw (Item 3) and install bracket (Item 2) loosely to back of compressor as shown. (See drilling instructions view if A/C compressor has heat shield, Fig. 1.)
5. Install hose assembly, kit 25537148.
6. Position bracket (Item 2) to ensure good fit to A/C muffler.
7. Tighten bolt/screw (Item 3) while limiting bracket rotation - torque to 55 N.m (37 lbs. ft.).
8. Recheck position of bracket and adjust if necessary to ensure good contact against A/C muffler.
9. Install clamp (Item 4) and tighten to 6 N.m (53 lbs. in.).
Parts are currently available through GMSPO.
General Motors bulletins are intended for use by professional technicians, not a "do-it-yourselfer". They are written to inform those technicians of conditions that may occur on some vehicles, or to provide information that could assist in the proper service of a vehicle. Properly trained technicians have the equipment, tools, safety instructions and know-how to do a job properly and safely. If a condition is described, do not assume that the bulletin applies to your vehicle, or that your vehicle will have that condition. See a General Motors dealer servicing your brand of General Motors vehicle for information on whether your vehicle may benefit from the information.