Removal Procedure
- Raise vehicle.
- Remove the left rear bumper fascia splash shield. Refer to Rear Bumper Fascia Splash Shield Replacement .
- Bend the EVAP canister vent valve retaining tab.
- Remove the valve from the EVAP canister vent valve bracket.
- Disconnect the EVAP canister vent valve electrical connector (2) from the EVAP canister vent valve (1).
- Loosen the vent hose clamp and remove the vent hose from the EVAP vent valve.
- Remove the EVAP canister vent valve from the vehicle.
Caution: Provide additional support when a vehicle is on a hoist in the following
ways:
• Before removing parts, support the opposite end. This helps prevent
the vehicle from slipping off. • Before removing major components, chain the vehicle frame to the
hoist pads at the same end as the removal. This helps avoid a tip-off.
Installation Procedure
- Connect the vent hose to the EVAP canister vent valve and tighten the hose clamp.
- Connect the EVAP canister vent valve electrical connector (2) to the EVAP canister vent valve (1).
- Install the EVAP canister vent valve to the EVAP canister vent valve bracket.
- Bend the EVAP canister vent valve retaining tab.
- Install the left rear bumper fascia splash shield. Refer to Rear Bumper Fascia Splash Shield Replacement .
- Lower the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the clamp to 4 N·m (35 lb in).
