For 1990-2009 cars only
Removal Procedure
Important:
• The rear window reveal molding cannot be replaced without removing
the rear window. • When replacing the rear window, the original rear window reveal
molding cannot be reused and must be replaced with a new rear window reveal
molding. • New rear window reveal moldings are primed and will adhere to
the urethane adhesive. • Be sure to prefit the rear window reveal molding to the rear window
then as an assembly on the body prior to actual installation. • A heat lamp may be used to make the rear window reveal molding
more pliable.
- Remove the rear window reveal molding using a flat-bladed tool, and carefully pry the end of rear window reveal molding out about 75 mm (3 inches).
- Grasp the rear window reveal molding by hand and slowly pull the molding away from the body.
- Remove the rear Window. Refer to Rear Window Replacement .
Installation Procedure
- Install the rear window reveal molding by starting from the center and hand press the rear window reveal molding into place.
- Prefit the rear window reveal molding to the rear window then as an assembly on the body prior to actual installation.
- Install the rear Window. Refer to Rear Window Replacement .
Tape can be applied to keep rear window reveal molding flush with rear window.
