GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 1999 🢒 Intrigue 🢒 Body and Accessories 🢒 Doors 🢒 Rear Side Door Window Switch Replacement

Removal Procedure

    Object Number: 164761 Size: SH

    Important: When removing a door trim panel or a switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.

    Important: Protect the trim panel at the point of insertion of the flat bladed tool to avoid damaging the door panel.

  1. Remove the power window/power door lock switch mounting plate using a small flat- bladed tool.

    2. Insert the tool at the rear of the switch mounting plate releasing the switch plate retainer.

  2. Lift the rear of the switch plate.
  3. Disconnect the electrical connectors.
  4. Remove the switch(s) from the mounting plate.

Installation Procedure

    Object Number: 164761 Size: SH
  1. Install the switch(s) to the mounting plate.

    2. Press down on the switch until the tabs are fully seated.

  2. Connect the electrical connector(s).
  3. Insert the front of the mounting plate into the trim panel.
  4. Press down on the rear of the mounting plate until the plate is fully seated.