SVS and/or Antilock Brake Lamp Illuminates, DTC P0410 (Replace Bus Bar)
| Subject: | Service Vehicle Soon and/or Antilock Brake Lamp Illuminates, DTC P0410 (Replace Bus Bar in Electrical Center) |
| Models: | 2000 Oldsmobile Intrigue |
| Built prior to VIN Breakpoint YF121427 |
| with NC1 (California-North East States Emissions) |
Condition
Some customers may comment that the Service Vehicle Soon and/or the ABS brake lamp is illuminated.
Cause
This condition may be caused by an insufficient connection between the bus bar and the fuse in the auxiliary fuse box.
Correction
Figure 1
Replace the bus bar within the auxiliary fuse box (Figure 1), using the following procedure.
| • | Disconnect the negative battery cable. |
| • | Disconnect the jumper which connects the Underhood Electrical Center and the auxiliary fuse box, located on the front of the right shock tower. |
| • | Remove the cover from the auxiliary fuse box by unlatching the lower retaining tab and lift the cover up and off. |
| • | Remove the Maxifuse from the auxiliary fuse box. Figure 2
|
| • | Inspect the auxiliary fuse box closely to determine the location of the three internal locking tabs. See the arrows in Figure 2 which hold the two halves of the auxiliary fuse box together. Using a small pocket screwdriver, depress the tabs to allow the center of the auxiliary fuse box to be lifted out of the housing. Figure 3
|
| • | Remove the wiring retainer from the side of the fuse block. |
| • | Inspect the new bus bar to locate the bus bar to housing retainers. Three tabs must be depressed individually with the pocket screwdriver. See the arrow in Figure 3 to allow the bus bar to be removed from the back side of the block. |
| • | Install bus bar, P/N 15354612, into the back of the fuse block. Verify that it snaps into place. |
| • | Reinstall the wiring retainer into the side of the fuse block. |
| • | Reinstall the fuse block back into the housing, ensuring that it is properly snapped into place and no wires are improperly trapped out of position. |
| • | Reinstall the MaxiFuse and the cover. |
| • | Install the jumper wire which connects the Underhood Electrical Center and the auxiliary fuse box. Tighten
|
| • | Reconnect the negative battery cable. Tighten
|
| • | Clear all codes using the Tech 2. |
Parts Information
Part Number | Description |
|---|---|
15354612 | Bus Bar |
Parts are currently available from GMSPO.
Warranty Information
For vehicles repaired under warranty, use:
Labor Operation | Description | Labor Time |
|---|---|---|
N0130 | Bus Bar - Replace | 0.3 hr |
