Schematic Reference: Instrument Cluster Schematics

Did you perform the Instrument Cluster Diagnostic System Check?

Go to Step 2

Go to Diagnostic System Check - Instrument Cluster

1. Install a scan tool.
2. Turn the ignition ON, with the engine OFF.
3. With a scan tool, observe the Display Trip Reset Sw. parameter in the IPC Data list.

Does the Display Trip Reset Sw. parameter display Off?

Go to Step 3

Go to Step 6

1. Press the TRIP RESET switch.
2. With a scan tool, observe the Display Trip Reset Sw. parameter.

Does the Display Trip Reset Sw. parameter display On?

Go to Step 4

Go to Step 5

Press the TRIP ODO switch.

Does the odometer toggle between trip and season?

Go to Testing for Intermittent Conditions and Poor Connections in Wiring Systems

Go to Step 7

1. Turn the ignition OFF.
2. Disconnect the trip odometer reset switch connector.
3. Connect a 3 amp fused jumper wire between the trip odometer reset switch signal circuit and a good ground. Refer to Circuit Testing in wiring systems.
4. Turn the ignition ON, with the engine OFF.
5. With a scan tool, observe the Display Trip Reset Sw. parameter.

Does the Display Trip Reset Sw. parameter display On?

Go to Step 11

Go to Step 8

1. Turn the ignition OFF.
2. Disconnect the trip odometer reset switch connector.
3. Turn the ignition ON, with the engine OFF.
4. With a scan tool, observe the Display Trip Reset Sw. parameter.

Does the Display Trip Reset Sw. parameter display Off?

Go to Step 12

Go to Step 9

1. Turn the ignition OFF.
2. Disconnect the trip odometer reset switch.
3. Connect a 3 amp fused jumper wire between the trip/season switch signal circuit and a good ground.
4. Turn the ignition ON, with the engine OFF.

Does the odometer toggle between trip and season when the ground is applied and removed?

Go to Step 12

Go to Step 10

Test the trip odometer reset switch signal circuit for an open, for a high resistance, or for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Test the trip odometer reset switch signal circuit for a short to ground. Refer to Circuit Testing and Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Test the trip/season switch signal circuit for an open, for a high resistance, for a short to ground, or for a short to voltage. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 13

Test the ground circuit of the trip odometer reset switch for an open or for a high resistance. Refer to Circuit Testing and to Wiring Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 12

Inspect for poor connections at the trip odometer reset switch. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 14

Inspect for poor connections at the harness connector of the IPC. Refer to Testing for Intermittent Conditions and Poor Connections and to Connector Repairs in Wiring Systems.

Did you find and correct the condition?

Go to Step 16

Go to Step 15

Replace the trip odometer reset switch. Refer to Trip Odometer Reset Switch Replacement .

Did you complete the replacement?

Go to Step 16

--

Replace the IPC. Refer to Instrument Cluster Replacement .

Did you complete the replacement?

Go to Step 16

--

Operate the system in order to verify the repair.

Did you correct the condition?

System OK

Go to Step 2