GM Service Manual Online
For 1990-2009 cars only

Tools Required

J 25070 Heat Gun

Removal Procedure

  1. When replacing an weld joint molding do the following:
  2. 1.1. Use tape to protect the mounting surface during removal.
    1.2. Use tape for alignment marks for installation of the molding.

    Object Number: 365407  Size: SH
  3. Heat the weld joint molding using a J 25070 .
  4. Apply heat using a circular motion for about 30 seconds.

    Notice: Use a plastic, flat-bladed tool to prevent paint damage when removing an emblem/name plate.


    Object Number: 321645  Size: SH
  5. Use a plastic, flat-bladed tool to remove the weld joint molding from the panel surface.
  6. When replacing, remove all adhesive as follows:
  7. • For body panels use a 3M™ Scotch Brite molding adhesive remover disk 3M™ P/N 07502 or equivalent.
    • For plastic panels use a lint free cloth and Varnish Makers and Painters (VMP) naptha or a 50/50 mixture by volume of isopropyl alcohol and water to remove the adhesive.

Installation Procedure


    Object Number: 365392  Size: SH

    Important: Apply the weld joint molding in an environment that is free from dust or other dirt that could come into contact with the sticky backing. Foreign material may cause improper adhesion.

  1. Heat the mounting surface to approximately 27-41°C (80-105°F).
  2. Ensure that the temperature of the weld joint molding is approximately 29-32°C (85-90°F).
  3. Important: Do not touch the adhesive backing on the weld joint molding.

  4. Remove the protective liner from the back of the molding.
  5. Position the molding to the location marks and press the molding to the mounting surface.
  6. Apply equal pressure along the molding to uniformly bond the item to the mounting surface.
  7. Remove the protective tape from the mounting surface.