GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Oldsmobile 🢒 2002 🢒 Intrigue 🢒 Engine 🢒 Engine Exhaust 🢒 Catalytic Converter Replacement

Removal Procedure
  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Disconnect the heated oxygen sensor (HO2S) wiring harness connector.

    3. Notice: Refer to Catalytic Converter Movement Notice in the Preface section.

  3. Support the exhaust system.

    4. Object Number: 372616 Size: SH
  4. Remove the catalytic converter bolts.
  5. Remove the catalytic converter gasket.

    6. Object Number: 407377 Size: SH
  6. Remove the right exhaust manifold pipe stud nuts.
  7. Remove the 3-way catalytic converter pipe.
  8. Remove the exhaust manifold pipe gasket.

    9. Object Number: 372612 Size: SH
  9. Remove the heated oxygen sensor (HO2S). Refer to Heated Oxygen Sensor 2 Replacement in Engine Controls - 3.5L.

Installation Procedure

    Object Number: 372612 Size: SH
  1. Install the heated oxygen sensor (HO2S). Refer to Heated Oxygen Sensor 2 Replacement in Engine Controls - 3.5L.

    2. Object Number: 407377 Size: SH
  2. Install the exhaust manifold gasket.

    3. Notice: Refer to Catalytic Converter Movement Notice in the Preface section.

  3. Install the 3-way catalytic converter.

    4. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  4. Install the right exhaust manifold pipe stud nuts.

    5. Tighten
    Tighten the nuts to 32 N·m (24 lb ft).


    Object Number: 372616 Size: SH
  5. Install the catalytic converter gasket.
  6. Install the catalytic converter bolts.

    7. Tighten
    Tighten the bolts to 45 N·m (33 lb ft).

  7. Remove the support from the exhaust system.
  8. Connect the heated oxygen sensor (HO2S) wiring harness connector.
  9. Inspect for leaks and underbody contact.
  10. Lower the vehicle.