For 1990-2009 cars only
Removal Procedure
- Remove the front bumper fascia deflector. Refer to Front End Fascia Deflector Replacement in Bumpers.
- Disconnect the electrical connector from the front fog lamp.
- Remove the front fascia lower support. Refer to Front Bumper Fascia Lower Support Replacement in Bumpers.
- Remove the fog lamp bulb/socket from the fog lamp by rotating counterclockwise.
- Remove the front fog lamp nuts from the front bumper impact bar.
- Remove the front fog lamp from the vehicle.
Installation Procedure
- Position the front fog lamp to the front bumper impact bar.
- Install the front fog lamp nuts to the front bumper impact bar.
- Install the front fascia lower support. Refer to Front Bumper Fascia Lower Support Replacement in Bumpers.
- Install the fog lamp bulb/socket to the fog lamp by rotating clockwise.
- Connect the electrical connector to the front fog lamp.
- Install the front bumper fascia deflector. Refer to Front End Fascia Deflector Replacement in Bumpers.
- Check and adjust the front fog lamp aim as necessary. Refer to Fog Lamp Aiming .
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the nuts to 10 N·m (89 lb in).
