GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the left side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
  2. Disconnect the electrical connectors.

  3. Object Number: 180295  Size: SH
  4. Remove the stop lamp switch (1) from the brake pedal bracket by turning the switch counterclockwise approximately ΒΌ turn, and pulling back.

Installation Procedure


    Object Number: 180295  Size: SH
  1. Install the stop lamp switch (1) into the slotted grooves until switch is fully depressed against the brake pedal (2), then turn the switch clockwise approximately ΒΌ turn, the switch should now be installed and adjusted.
  2. Connect the electrical connectors.
  3. Install the left side instrument panel insulator. Refer to Instrument Panel Insulator Panel Replacement - Left Side in Instrument Panel, Gages and Console.
  4. If necessary, adjust the stop lamp switch. Refer to Stop Lamp Switch Adjustment .