GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1999 🢒 Bonneville 🢒 Body and Accessories 🢒 Wiring Systems 🢒 Steering Wheel Inflatable Restraint Module Replacement

Removal Procedure

    Caution: When you are carrying an undeployed inflator module:

       • Do not carry the inflator module by the wires or connector on the inflator module
       • Make sure the bag opening points away from you
    When you are storing an undeployed inflator module, make sure the bag opening points away from the surface on which the inflator module rests. When you are storing a steering column, do not rest the column with the bag opening facing down and the column vertical. Provide free space for the air bag to expand in case of an accidental deployment. Otherwise, personal injury may result.

  1. Disable the SIR System. Refer to Disabling the SIR System .

    2. Object Number: 298865 Size: MH
  2. Remove the 2 screws (9) at the back of the steering wheel (1).

    3. Important: Note the wire routing for assembly reference.

  3. Position the inflator module (3) in order to gain access to the wire connectors.
  4. Push in and rotate the horn contact lead (6) counterclockwise.
  5. Remove the horn contact lead (6) from the steering column horn tower.
  6. Remove the horn contact lead (6).
  7. Remove the retainer (CPA) (10) from the SIR wiring connector.
  8. Remove the SIR wiring connector from the inflatable restraint steering wheel module (3).
  9. Disconnect the steering wheel control switch connector (7).
  10. Remove the inflatable restraint steering wheel module (3).

Installation Procedure
  1. Connect the steering wheel switch connector, if equipped.

    2. Object Number: 298865 Size: MH
  2. Install the retainer (CPA) (10) to the SIR wiring connector.
  3. Route the horn contact lead (6) to the steering column horn tower.
  4. Push the lead (6) into the horn tower.
  5. Rotate the lead (6) clockwise to locked position.
  6. Install the horn ground to lead (6).
  7. Install the SIR connector and retainer (CPA).

    8. Important: Do not pinch any wires.

  8. Install the inflatable restraint steering wheel module (3) to the steering wheel (1).

    9. First install the top surface of the module (3) in order to ease assembly and fit.

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  9. Install the 2 screws (9) through the back of the steering wheel (1) to the inflator module (3).

    10. Tighten
    Tighten the screws to 3 N·m (27 lb in).

  10. Enable the SIR system. Refer to Enabling the SIR System .