Did you perform the Instrument Cluster System Check?

--

Go to Step 2

Go to Instrument Cluster System Check

1. Connect a J 39200 DMM across the battery's positive and negative terminals.
2. Turn the ignition switch to the RUN position.

Is the voltage reading approximately the same as the reading on the vehicle's volt gauge?

--

Go to Starter and Charging in Engine Electrical.

Go to Step 3

Are the other gauges operating properly?

--

Go to Step 4

Go to Instrument Cluster Inoperative

Replace the instrument cluster. Refer to IP Cluster Replacement in Instrument Panel, Gauges, and Console.

Did you complete the repair?

--

Go to Instrument Cluster System Check

--