Important: The automatic transmission control lever solenoid is a part of the brake transmission shift interlock (BTSI) system. The solenoid prevents the operator from shifting the automatic transmission control out of the (P) Park position unless the brake pedal is depressed.

1. Disconnect the negative battery cable. Refer to

   Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

2. Remove the front floor console trim plate. Refer to Instrument Panel, Gauges, and Console.



3. Disconnect the wiring harness electrical connector from the shift lock control solenoid.



4. Remove the shift lock control solenoid by unsnapping the retainers.

1. Install the shift lock control solenoid. Snap the retainers into place.



2. Connect the electrical connector to the shift lock control solenoid.
3. Install the front floor console trim plate. Refer to Instrument Panel, Gauges, and Console.
4. Connect the negative battery cable.