Power Steering Fluid Reservoir Replacement - Off Vehicle 5.7L VIN G (Integral Unit)

1. Remove power steering pump (LS1 only). Refer to Power Steering Pump Replacement in Power Steering.
2. Remove the retainer clips from the sides of the pump/reservoir assembly.

Important: It will be necessary to use a flat-head screwdriver to slightly pry up the retainer clip tabs to allow the clips to slide from the assembly.

3. Remove reservoir and seal from pump.

1. Install the reservoir and seal to pump.

Important: Seal may be reused if in good condition. Examine for any visible deterioration and if present, replace seal.

2. Slide retainer clips onto pump/reservoir assembly.

Important: Ensure that retainer clip tabs lock down into their mating groove in the pump. When fully installed, the clips should "click" as they reach the fully installed position.

3. Install the power steering pump (LS1 only). Refer to Power Steering Pump Replacement in Power Steering.
4. Refill and bleed power steering system. Refer to Power Steering System Bleeding .