Conditions for Setting the DTC
The signal received by the BCM from the remote control door lock transmitter was valid. No malfunctions are detected by the BCM.
Action Taken When the DTC Sets
The remote control door lock transmitter and BCM functions operate normally.
Conditions for Clearing the DTC
DTC 41 is set when all of the following conditions occur:
| • | The BCM is in the diagnostic mode |
| • | Any button on the remote control door lock transmitter is pressed |
| • | The BCM and the Remote control door lock transmitter are operating correctly |
DTC 41 is automatically cleared after it is displayed. Any button on the remote control door lock transmitter must be pressed again to display DTC 41 again.
Test Description
The numbers below refer to the step numbers on the diagnostic table.
-
This step tests the BCM to see if DTC 41 is displayed by the BCM.
-
This step tests the remote control door lock transmitter.
Step | Action | Value(s) | Yes | No |
|---|---|---|---|---|
1 |
Does the BCM display DTC 41? | -- | ||
2 |
Does the BCM display DTC 41? | -- | System OK | |
3 | Replace the BCM. Refer to Body Control Module Replacement . Is the repair complete? | -- | System OK | -- |
4 | Attempt to operate all of the remote functions using the transmitter. Do all of the transmitter functions operate? | -- | System OK | Go to |
