GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1999 🢒 Firebird 🢒 General Information 🢒 General Information 🢒 Stabilizer Shaft Link Replacement

Removal Procedure

    Object Number: 181244 Size: SH
  1. Raise and suitably support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  2. Remove the nut (1) and bolt (3) assembly.
  3. Remove the link (4) from the bracket.
  4. Remove the bolts (2) from the bracket (5).
  5. Remove the bracket (5) from the underbody pan (6).

Installation Procedure

    Object Number: 181244 Size: SH
  1. Position the bracket (5) to the underbody pan (6).

    2. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  2. Install the bolts (2) to the bracket (5).

    3. Tighten
    Tighten the bolts (2) to 23 N·m (17 lb ft).

  3. Position the link (4) to the bracket (5).
  4. Install the bolt (3) and the nut (1) to the link (4).

    5. Tighten
    Tighten the bolt (3) and the nut (1) to 22 N·m (16 lb ft).

  5. Lower the vehicle.