Creak coming from the upper B-pillar/roof area on the passenger side. Usually only happens over 16°C (60°F) ambient temperature.
Sheet metal interference in the middle to the upper area of the B-pillar.
Remove B-pillar quarter inner trim finishing panel. Test drive the vehicle, listen for noise over rough roads.
Strike the B-pillar sheet metal (1), inside the vehicle, with a ball peened hammer to put a slight indentation in the inside body panel.
Rattle from the rear speaker located on the rear quarter trim panel.
The rivets do not hold well due to improper installation.
• | Remove the rear quarter trim. |
• | Check speaker attachment to the trim for looseness. |
Install new rivets or isolation material as necessary.
Rattle from the rear of the vehicle.
Rear compartment closeout panel (2) rattles against the side trim.
Remove the closeout panel (2) and test drive the vehicle.
Apply a 2 x 5 in foam tape (1) in each corner.
A rattle coming from the rear hatch area.
• | The hatch latch is not in the correct position, both cross-car and up/down. |
• | Overslam bumpers are not properly set. |
Test drive the vehicle and, with the aid of a helper, push up on the rear compartment lift window panel to stop the noise.
• | Loosen the latch. |
• | Center with the striker and retighten. Be sure to provide equal clearance to the latch sides. |
• | Lower the lift window pane and run bumpers out to a point that a single piece of paper can barely be pulled out when the rear panel is fully closed. |
Rattle from the rear compartment trim area.
Trim is loose due to misinstalled or missing fasteners.
Carefully pull the rear compartment trim down to view behind, look for misinstalled or missing fasteners.
Install new fastener.
High pitched itch coming from the rear (right, left or both) of the vehicle over moderate to rough roads. Sounds similar to sheet metal joint creaks.
The stryofoam inserts located behind the quarter trim panel are contacting and rubbing against the quarter inner sheet metal surfaces.
Look for witness marks on the styrofoam insert of the quarter panel inner sheet metal surface.
Apply 3 pieces of 30 x 80 mm GM 6068M closed cell foam (P/N 22638774) or similar isolation material at specified location. Wrap foam around edges approximately 1/4 inch.