Generator Brace Replacement 3.8L Engine

1. Remove the generator. Refer to Generator Replacement .
2. Remove the canister purge solenoid. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement in Engine Controls  - 3.8L.



3. Remove the generator rear brace bolts (5).
4. Remove the generator rear brace (4).

1. Install the generator rear brace (4).

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install generator rear brace bolts (5).

Tighten
Tighten the generator rear brace bolts to 25 N·m (18 lb ft).

3. Install the canister purge solenoid. Refer to Evaporative Emission Canister Purge Solenoid Valve Replacement in Engine Controls -  3.8L
4. Install the generator. Refer to Generator Replacement .