Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

1. Disconnect the negative battery cable.
2. Remove the connector from the CPP switch.



3. Remove the CPP switch (2) from the clutch and from the brake pedal bracket by turning the CPP switch counterclockwise.
4. Remove the CPP switch lock nut (1) from the CPP switch.
5. Inspect the CPP switch for damage. Replace the switch as necessary.

Tools Required

J 39200 Digital Multimeter

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

1. Install the CPP switch lock nut to the CPP switch.

Tighten
Tighten the CPP switch lock nut (1) to 13  N·m (115 lb in).

2. Use J 39200 in order to adjust the CPP switch.



3. Install the clutch pedal position (CPP) switch (2) into the clutch and into the brake pedal bracket by turning the CPP switch clockwise.



4. Depress the clutch pedal (2) to the floor (3). Return the clutch pedal 15-30 mm (0.6-1.2 in) from the floor.



5. Adjust the probes of J 39200 in contact with both leads of the CPP switch electrical connector (2).
6. Adjust the CPP switch by threading the switch into the clutch and into the brake pedal bracket until continuity is achieved.
7. Install the CPP switch lock nut.

Tighten
Tighten the CPP switch lock nut to 13 N·m (115 lb in)

8. Connect the connector to the CPP switch.
9. Connect the negative battery cable.