Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable
the SIR System. Refer to
Disabling the SIR System
in SIR.
- Remove the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Disconnect the rear wiper/washer electrical connector.
- Use a pick in order to push up on the clip on the bottom of the
rear wiper/washer switch (9).
- Remove the rear wiper/washer switch (9) from the left garnish
trim panel (10).
Installation Procedure
- Connect
the rear wiper/washer electrical connector.
- Install the rear wiper/washer switch (9) to the left garnish
trim panel (10). Push in the switch until the clip engages fully.
- Install the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Enable the SIR System. Refer to
Enabling the SIR System
in SIR.