Removal Procedure
Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:
• | Unnecessary SIR system repairs |
In order to avoid the above conditions, observe the following guidelines:
• | Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring. |
• | If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System. |
- Disable the
SIR. Refer to
Disabling the SIR System
in SIR.
- Remove the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Disconnect the rear defogger switch connector.
- Release the clip at the bottom of the rear defogger switch (9)
by pushing up on the clip with a pick.
- Remove the rear defogger switch (9) from the left garnish
trim panel (10).
Installation Procedure
- Connect
the rear defogger switch connector.
- Install the rear defogger switch (9) to the left garnish
trim panel (10). Push the switch until the clip completely engages.
- Install the knee bolster. Refer to
Knee Bolster Replacement
in Instrument Panel, Gauges and Console.
- Enable the SIR. Refer to
Enabling the SIR System
in SIR.