Transaxle Side Case Right Case

Tools Required

1. Remove one bolt and the speedometer driven gear case from the right case.



2. Use a screwdriver in order to remove the input shaft oil seal (2) from the right case (1) .



3. Remove the following items from the right case:

•	Two bolts (2)

•	The reverse gearshift lever (1)

Important: If the right input shaft bearing remains in the right case upon removal of the gear cluster and the gearshift shaft assembly, remove the right input shaft bearing.

4. Use J 23907 with J 29369-2 in order to remove the right countershaft bearing race from the right case.



5. Remove the drain plug/magnet from the left case.



6. Remove the gearshift arm bolt and the gearshift arm from the gearshift shaft.



7. Remove the following components from the right case:

•	The gearshift shaft bolt and the washer (1)

•	The gearshift shaft spring (2)

•	The steel ball (3)




8. Remove the gearshift shaft (3) from the right case (1) .



9. Remove the gearshift shaft boot (2) from the case.



10. Remove the gearshift shaft oil seal (1) from the right case (2) .
11. Clean all of the case components and the internal parts thoroughly with solvent.

Dry the components.

12. Inspect all of the components for excessive wear or damage. Replace as necessary.

Transaxle Side Case Left Case

Tools Required

1. If the left countershaft bearing race is damaged, use J 23907 with J 29369-2 in order to remove the race (2) from the left case (1).



2. Remove the bolt and the oil gutter from the left case.



3. Remove the left differential oil seal (1) from the left case.
4. Clean all of the case components and the internal parts thoroughly with solvent. Dry the components.
5. Inspect all the components for excessive wear or damage. Replace as necessary.

1. Use the J 35538 and a hammer in order to install the left differential oil seal.
2. Apply J 36850 to the left differential oil seal lip.



3. Apply Loctite® 414 GM P/N 12345493 or equivalent to the threaded portion of the oil gutter bolt.




Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the oil gutter into the left case. Secure the oil gutter with the oil gutter bolt.

Tighten
Tighten the oil gutter bolt to 12 N·m (8.5 lb ft).