Quarter Outer Panel Sectioning Sedan Bond-On

Caution: Refer to Approved Equipment for Collision Repair Caution in the Preface section.

Important: This adhesive bonding procedure repreents one manufacturer's installation application. Other manufacturers' procedures may vary, including MIG welding in some areas of the repair. Always follow the system manufacturer's instructions for application, handling, and curing.

Important: Before beginning the repair, refer to Metal Panel Bonding for proper adhesive preparations and general information.

1. Disconnect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.
2. Disable the SIR system. Refer to SIR Disabling and Enabling in SIR.
3. Restore as much of the damage as possible to factory specifications. Refer to Dimensions - Body .
4. Remove all related panels and components.
5. Note the location and remove the sealers and anti-corrosion materials from the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.



6. Section the sail panel (a) and the rocker panel (b).

•	At the sail panel, measure from the back glass opening down 120 mm (4 3/4 in). Scribe a line.

•	At the rocker panel, measure 70 mm (2 3/4 in) rearward from the rocker panel locating hole. Scribe a line.




7. Locate and drill out all factory welds. Note the number and location of welds for installation of the quarter panel.

Important: Do not damage any other panel or reinforcements when cutting at the marked locations.




8. Cut the panel at the marked locations.



9. Remove the lower quarter panel.

1. Grind the surface of the body mating flanges to bare steel.



2. Grind the quarter panel mating flanges to remove the E-coating. Take care not to damage the corners or thin the metal during the grinding operation.
3. Clean the mating surfaces.
4. Perform the sectioning procedure. Refer to Overlap/Backing Plate Sectioning .




Important: The adhesive has a 40-50 minute working time. Do not allow the adhesive to totally cure off the vehicle, as proper alignment of the lower quarter panel to the body will be difficult.

5. Apply a 3-6 mm (1/8-1/4 in) bead of metal panel bonding adhesive GM P/N 12378567 (Canadian P/N 88901675) or equivalent to both of the mating surfaces.
6. Using a small acid brush, spread a coat of adhesive to cover all the bare metal surfaces to ensure corrosion protection.
7. Apply a 9-13 mm (3/8-1/2 in) bead of metal panel bonding adhesive GM P/N 12378567 (Canadian P/N 88901675) or equivalent to the service part mating surface.




Important: DO NOT pull the panels apart after joined together. Slide the panels against each other to realign the panels.

8. Install the quarter panel to the body.



9. Clamp the quarter panel into position as required.
10. Using lacquer thinner remove the excess adhesive from the lower quarter panel area.
11. Apply the sealers and anti-corrosion materials to the repair area, as necessary. Refer to Anti-Corrosion Treatment and Repair in Paint and Coatings.
12. Paint the repair area. Refer to Basecoat/Clearcoat Paint Systems in Paint and Coatings.
13. Install all related panels and components.
14. Enable the SIR system. Refer to SIR Disabling and Enabling in SIR.
15. Connect the negative battery cable. Refer to Battery Negative Cable Disconnection and Connection in Engine Electrical.