GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2009 🢒 G8 🢒 Engine 🢒 Engine Mechanical - 2.8L, 3.0L, 3.2L, or 3.6L 🢒 Engine Oil Level Sensor and/or Switch Replacement

Removal Procedure

    Warning: Refer to Safety Glasses Warning in the Preface section.

    Danger: To avoid any vehicle damage, serious personal injury or death when major components are removed from the vehicle and the vehicle is supported by a hoist, support the vehicle with jack stands at the opposite end from which the components are being removed and strap the vehicle to the hoist.

  1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
  2. Remove the Engine Splash Shield. Refer to Engine Splash Shield Replacement.

    3. Object Number: 1958141 Size: SH
  3. Drain the engine oil. Refer to Engine Oil and Oil Filter Replacement.
  4. Disconnect the engine oil level switch electrical connector (2).
  5. Remove the engine oil level switch to oil pan retaining bolt (4).
  6. Remove the engine oil level switch (3) from the oil pan (1).

Installation Procedure

    Caution: Refer to Fastener Caution in the Preface section.


    Object Number: 1958141 Size: SH
  1. Install the engine oil level switch bolt (2) to the oil pan (3) and tighten to 20 N·m (15 lb ft).
  2. Connect the engine oil level switch electrical connector (1).
  3. Install the front air deflector. Refer to Front Air Deflector Replacement.
  4. Lower the vehicle.
  5. Fill the engine oil. Refer to Engine Oil and Oil Filter Replacement.
  6. Inspect for oil leaks after engine start up.
  7. Reset the GM Oil Life System. Refer to GM Oil Life System Resetting.