Removal Procedure
- Remove the door trim panel. Refer to
Front Side Door Trim Panel Replacement.
- Pull back the forward half of the water deflector from the door panel to access the check link.
Note: The door check link to pillar retaining bolt (2) is a single use part and must be discarded after removal.
- Remove the door check link to pillar retaining bolt (2).
Discard the bolt.
- Remove the door check link to door retaining nuts (1).
Note: Remove the check link (1) through the front lower access hole.
- Remove the door check link (1) from the door (2).
Installation Procedure
Note: Install the check link (1) through the front lower access hole.
- Install the door check link (1) to the door (2).
Caution: Refer to Fastener Caution in the Preface section.
- Install the NEW door check link to pillar retaining bolt (1) and tighten to
25 N·m (18 lb in).
- Install the door check link to door retaining nuts (1) and tighten to
6 N·m (53 lb in).
Note: Firmly press the water deflector where adhesive is applied to make sure of a water tight bond.
- Install the water deflector to the door.
- Install the door trim panel. Refer to
Front Side Door Trim Panel Replacement.