GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2006 🢒 GTO 🢒 Engine 🢒 Engine Cooling 🢒 Engine Coolant Fan Motor Replacement

Removal Procedure

    Object Number: 1277322 Size: SH
  1. Remove the cooling fan and shroud assembly. Refer to Engine Cooling Fan Replacement .
  2. Disconnect the intermediate fan motor electrical connector (1), then remove the motor assembly wire harness (2) from the fan shroud retaining clips.
    3. 2.1. Remove four screws (3), attaching the fan motor and the fan assemblies to the fan shroud.
    2.2. Remove the fan motor and wiring from the fan shroud.

Installation Procedure

    Object Number: 1277322 Size: SH
  1. Position the fan motor assembly.

    2. Notice: Refer to Fastener Notice in the Preface section.

    1.1. Install four screws (3), attaching the fan motor and the fan assemblies to the fan shroud.

    Tighten
    Tighten the fan motor screws to 5 N·m (62 lb in).

    1.2. Install the motor assembly wire harness (2) to the fan shroud retaining clips, then connect the intermediate fan motor electrical connector (1).

    Important: To avoid damage to the fan motor shaft, do not lift the fan and shroud assembly by the fan rings.

  2. Install the fan and shroud assembly. Refer to Engine Cooling Fan Replacement .