Removal Procedure
Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing
any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to
the vehicle or its components.
- Disconnect
the negative battery cable.
- Remove the accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
in Instrument
Panel, Gauges and Console.
- Remove the radio mounting
screws.
- Pull the radio (2) rearward.
- Disconnect the following radio components:
| • | All electrical connections |
| • | The antenna lead connection |
- Remove the radio from the vehicle.
Installation Procedure
- Connect the following
radio components:
| • | All electrical connections |
| • | The antenna lead connection |
- Install the radio (2) to the vehicle.
Notice: Use the correct fastener in the correct location. Replacement fasteners
must be the correct part number for that application. Fasteners requiring
replacement or fasteners requiring the use of thread locking compound or sealant
are identified in the service procedure. Do not use paints, lubricants, or
corrosion inhibitors on fasteners or fastener joint surfaces unless specified.
These coatings affect fastener torque and joint clamping force and may damage
the fastener. Use the correct tightening sequence and specifications when
installing fasteners in order to avoid damage to parts and systems.
- Install the radio
mounting screws.
Tighten
Tighten the radio mounting screws to 3 N·m (25 lb in).
- Install the accessory trim plate. Refer to
Instrument Panel Accessory Trim Plate Replacement
in Instrument
Panel, Gauges and Console
- Connect the negative battery cable.
