Removal Procedure
- Perform the following procedure in order to place the sunroof
into the full vent position:
• | Open the sunroof to the fullopen position. |
• | Release the switch when the front of the glass panel touches the
roof. |
- Place the sunroof sunshade (1)
into the open position.
- Push the guide (2) on the left front sunroof sunshade 91)
toward the middle of the vehicle.
This will overcome the spring pressure and disengage the guide (2)
from the track on the left front sunroof sunshade (1).
- Slide the sunroof sunshade (2) into the closed position.
- Push the guide on the left rear sunroof sunshade toward the middle
of the vehicle.
This will overcome the spring pressure and disengage the guide from
the track on the left rear sunroof sunshade.
- Remove the sunroof sunshade (2) from the vehicle using
the following procedure:
6.1. | Pull the sunroof sunshade (2) towards the left side of
the vehicle in order to disengage the guides on the right side sunroof sunshade. |
6.2. | Pull the sunroof sunshade out between the glass panel and the
roof. |
Installation Procedure
- Install the sunroof sunshade (2)
into the vehicle between the roof and the glass panel.
- Position the guides on the right side sunroof sunshade to the
guide rail.
- Engage the guide on the left rear sunroof sunshade to the guide
rail.
Use a flat bladed tool.
- Slide the sunroof sunshade (2) to the open position.
- Engage the guide on the left front sunroof sunshade to the guide
rail.
- Cycle the sunshade by hand to check for proper operation.