For 1990-2009 cars only
Removal Procedure
- Use a heat gun 152 mm (6 in) from the surface in order to heat the molding.
- Use a flat-bladed tool in order to peel the door finish panel from the door surface.
- Remove the door finish panel.
- Beginning at one end, pull the center pins from the door rocker molding support retainers.
- Remove the door finish panel support from the door.
Apply the heat for approximately 30 seconds using a circular motion.
Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.
Installation Procedure
- Align the clips on the door finish panel support into the holes in the door.
- Use Varnish Makers and Painters (VM&P) naptha in order to clean the body panel.
- Use a heat lamp or heat gun in order to warm the body panel to a minimum of 21°C (70°F).
- Install the bottom flange of the door finish panel into the support.
- Install the locating pins into the door.
- Peel the backing from the door finish panel.
- Push the door finish panel inboard in order to ensure maximum bond to the body.
Snap the clips into the holes.
Do not touch the adhesive backing.
