GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1999 🢒 Grand Prix 🢒 Body and Accessories 🢒 Exterior Trim 🢒 Front Bumper Fascia Emblem Replacement

Removal Procedure

    Object Number: 320041 Size: SH
  1. Use a heat gun 152 mm (6 in) from the surface in order to heat the front bumper fascia emblem.

    2. Apply the heat for approximately 30 seconds using a circular motion.

    Notice: When removing body panels, apply tape to corners of panel and adjacent surfaces to help prevent paint damage.

  2. Use a flat-bladed tool in order to peel the front bumper fascia emblem from the front bumper fascia surface.
  3. Remove the front bumper fascia emblem adhesive from the front bumper fascia using 3M ScotchBrite molding adhesive remover disk 3M P/N 07501 or equivalent.

    4. Caution: Exposure to isocyanates during paint preparation and application processes can cause severe breathing problems. Read and follow all of the instructions from the manufacturers of painting materials, equipment, and protective gear.

  4. Use Varnish Makers and Painters (VM&P) naptha or equivalent in order to clean the body panel.

Installation Procedure
  1. Use a heat lamp or heat gun in order to warm the front bumper fascia to a minimum of 21°C (70°F).

    2. Object Number: 320041 Size: SH
  2. Peel the backing from the front end of the front bumper fascia emblem.

    3. Do not touch the adhesive backing.

  3. Press the front bumper fascia emblem to the front bumper fascia while continuing to remove the backing.
  4. Hand roll the front bumper fascia emblem to the front bumper fascia in order to ensure proper adhesion.
  5. Inspect the front bumper fascia emblem ends for bonding.

    6. Hand roll the loose ends.