Caution:  When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury.

1. Remove the hood. Refer to Hood Replacement .
2. Remove the rear hood side seal. Refer to Hood Rear Outer Seal Replacement .
3. Remove the hood assist rod. Refer to Hood Open Assist Rod Replacement .



4. Remove the hinge to fender bolts.



5. Center punch the spot weld



6. Drill out the spot weld using a 9.5 mm (3/8 in) drill bit.
7. Remove the hood hinge from the fender.

1. Install the hood hinge to the fender.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

2. Install the hood hinge to the fender bolts.

Tighten
Tighten the hood hinge to fender bolts to 25 N·m (18 lb ft).

3. Install the rear hood side seal. Refer to Hood Rear Outer Seal Replacement .
4. Install the hood assist rod. Refer to Hood Open Assist Rod Replacement .
5. Install the hood. Refer to Hood Replacement .
6. Adjust the hood as required. Refer to Hood Adjustment .