For 1990-2009 cars only
Removal Procedure
- Use a flat-bladed tool in order to remove the power window and door lock switch plate assembly (1) from the trim panel.
- Insert the tool at the rear of the switch plate (1). Press forward in order to release the switch plate retainers.
- Remove the switch from the mounting plate.
- Disconnect the electrical connector.
- Remove the switch from the mounting plate.
Important: When removing a door trim panel or switch plate, the ignition switch must be in the OFF position. This will eliminate the possibility of shorting out the switch if a flat-bladed tool, awl or metal object is used to remove the switch from the harness.
Important: Use protective coating/tape at the point of insertion of the flat surface tool. Damage to the inner door panel may occur if it is not protected.
Installation Procedure
- Install the switch tabs into the mounting plate slots.
- Press down on the tabs in order to secure the mounting plate.
- Connect the electrical connector.
- Snap the switch and mounting plate into the trim panel in order to secure the switch and mounting plate.
