- Install the turn signal and multifunction switch assembly (2) onto the steering column tilt head assembly.
- Verify that the electrical contact of the turn signal and multifunction switch assembly (2) rests on the turn signal cancel cam assembly.
- Screw the 2 pan head tapping screws (1) into the turn signal and multifunction assembly (2).
- Slide the 2 connectors (2) of the turn signal and multifunction switch assembly into the bulkhead connector (1).
- Reconnect the turn signal and multifunction switch assembly connector to the inflatable restraint steering wheel module coil connector.
- Attach the wire harness assembly (1) to the steering column with new wire harness straps.
- Install the wire harness assembly (1) to wire harness strap (2).
- Install the upper and lower trim covers. Refer to Steering Column Trim Covers - Assemble - Off Vehicle .
- Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System in SIR.
Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.
Tighten
Tighten the screws to 7 N·m (62 lb in).
Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.
