GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Grand Prix 🢒 Steering 🢒 Steering Wheel and Column 🢒 Electronic Column Lock Module - Disassemble - Off Vehicle

    Object Number: 324877 Size: SH

    Caution: This vehicle is equipped with a Supplemental Inflatable Restraint (SIR) System. Failure to follow the correct procedure could cause the following conditions:

       • Air bag deployment
       • Personal injury
       • Unnecessary SIR system repairs
    In order to avoid the above conditions, observe the following guidelines:
       • Refer to SIR Component Views in order to determine if you are performing service on or near the SIR components or the SIR wiring.
       • If you are performing service on or near the SIR components or the SIR wiring, disable the SIR system. Refer to Disabling the SIR System.

  1. Disable the inflatable restraint steering wheel module. Refer to Disabling the SIR System in SIR.
  2. Remove the steering column tilt head housing. Refer to Steering Column Tilt Head Housing - Disassemble - Off Vehicle .
  3. Remove the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
  4. Slide the PASSKEY® III (2) off of the electronic lock module assembly (1).

    5. Object Number: 368484 Size: SH
  5. Remove the connector (2) from the electric park lock (3).
  6. Remove the TORX® head screw (1) from the electric park lock (3).

    7. Object Number: 368489 Size: SH
  7. Remove the electric park lock (2) from the electronic lock module assembly (1).

    8. Object Number: 306267 Size: SH
  8. Remove the key alarm connector (1) from the electronic lock module assembly (2).
    9. 8.1. Rotate the key alarm connector (1) 90 degrees.
    8.2. Pull the key alarm connector (1) out of the electronic lock module assembly (2).

    Object Number: 306272 Size: SH
  9. Remove the 2 tapping screws (2) from the ignition and key alarm switch assembly (1).
  10. Let the ignition and key alarm switch assembly (1) hang freely.

    11. Object Number: 368510 Size: SH

    Important: The lock bolt assembly (4) is under slight spring tension from the lock bolt spring (3). Hold the lock bolt (4) in place while removing the electronic lock module assembly (2).

  11. Remove the 3 pan head tapping screws (1) from the electronic lock module assembly (2).
  12. Remove the electronic lock module assembly (2) from the steering column tilt head assembly (5).
  13. Remove the lock bolt assembly (4) from the steering column tilt head assembly (5).
  14. Remove the lock bolt spring (3) from the lock bolt assembly (4).