GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 2002 🢒 Grand Prix 🢒 Steering 🢒 Steering Wheel and Column 🢒 Electronic Column Lock Module - Assemble - Off Vehicle

    Object Number: 368510 Size: SH
  1. Install the lock bolt spring (3) into the steering column tilt head assembly (5).
  2. Position the cutout in the lock bolt assembly (4) at the 6 o'clock position.
  3. Install the lock bolt assembly (4) into the steering column tilt head assembly (5).
  4. Push the lock bolt assembly (4) into the steering column tilt head assembly (5) until the lock bolt assembly (4) is flush with the steering column tilt head assembly (5).
  5. Align the electronic lock module assembly (2) with the steering column tilt head assembly (5).

    6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  6. Screw the 3 pan head tapping screws (1) into the electronic lock module assembly (2).

    7. Tighten
    Tighten the screws to 7 N·m (62 lb in).


    Object Number: 306272 Size: SH

    Caution: Improper routing of the wire harness assembly may damage the inflatable restraint steering wheel module coil. This may result in a malfunction of the coil, which may cause personal injury.

  7. Install the ignition and key alarm switch assembly (1) onto the electronic lock module assembly.
  8. Screw the 2 tapping screws (2) into the ignition and key alarm switch assembly (1).

    9. Tighten
    Tighten the screws to 1.5 N·m (13 lb in).


    Object Number: 368489 Size: SH
  9. Install the electric park lock (2) onto the electronic lock module assembly (1).

    10. Object Number: 368484 Size: SH
  10. Screw the TORX® head screw (1) into the electric park lock (3).

    11. Tighten
    Tighten the screw to 1.5 N·m (13 lb in).

  11. Reconnect the connector (2) to the electric park lock (3).

    12. Object Number: 306267 Size: SH
  12. Install the key alarm connector (1) onto the electronic lock module assembly (2).
    13. 12.1. Push the key alarm connector (1) into the electronic lock module assembly (2).
    12.2. Rotate the key alarm connector 90 degrees so that the key alarm connector (1) locks into place.
  13. Install the steering column lock cylinder set.

    14. Object Number: 324877 Size: SH
  14. Slide the PASSKEY® III (2) onto the electronic lock module assembly (1).
  15. Install the steering column tilt head housing. Refer to Steering Column Tilt Head Housing - Assemble - Off Vehicle .
  16. Install the steering column lock cylinder set. Refer to Ignition Lock Cylinder Replacement - On Vehicle .
  17. Enable the inflatable restraint steering wheel module. Refer to Enabling the SIR System .