Roof Console Replacement With Storage

1. Remove the screw located by the windshield.
2. Insert a flat-bladed tool to the rear of the off/on switches and detach the console lamp assembly.
3. Disconnect the lamp electric connector.
4. Open the storage compartments.



5. Remove the overhead console screws.
6. Remove the overhead console housing.
7. Remove the backing plate.

1. Install the backing plate.
2. Install the overhead console housing.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

3. Install the overhead console screws.

Tighten
Tighten the overhead console screws to 2 N·m (18 lb in).

4. Install the screw located by the windshield.

Tighten
Tighten the overhead console screw to 2 N·m (18 lb in).

5. Close the storage units.
6. Connect the lamp electrical connector.
7. Install the overhead console reading lamp.

Roof Console Replacement W/Out Storage

1. Insert a flat-tipped tool at the rear edge of the console (1) and rotate rearward to release the clips.



2. Pull the console down and disconnect the electrical connectors to the sunroof switch (1) and to the garage door transmitter.
3. Remove the overhead console from the vehicle.

1. Position the overhead console in the vehicle



2. Connect the electrical connector to the sunroof switch (1) and to the garage door transmitter.
3. Position the front tabs in the sunroof bezel.
4. Press the console up to secure the rear clips.