Tools Required

J 38778 Door Trim Pad and Garnish Clip Remover

1. Open the hood.
2. Remove the left front headlamp. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting Systems.
3. If the vehicle is equipped with a supercharger:

3.1.	Use J 38778 to remove the push-in retainers from the air intake ducts.

3.2.	Remove the air intake ducts.

Important: Block the hood latch in order to prevent the hood from locking until you have installed the hood latch release cable.

4. Squeeze the cable retainer to remove the release from the hood latch.
5. Remove the front sheet metal diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .
6. Remove the air cleaner. Refer to the following procedures:

•	Air Cleaner Assembly Replacement in Engine Controls-3.1L

•	Air Cleaner Assembly Replacement in Engine Controls-3.8L

7. Tie a wire or string to the end of the hood release cable. Ensure that the end of the wire or string remains in the engine compartment.



8. Remove the hood release cable retainers from the engine compartment side rail.
9. Pull the carpet back to access the hood release.



10. Remove the nut from the parking brake bracket.
11. Remove the bolts from the hood release handle.
12. Remove the hood release cable from the hood release handle.



13. Use a small flat-bladed tool to remove the grommet from the dash panel.
14. Remove the hood latch release cable from the dash panel.

1. Tie the hood latch release cable to a wire or string. Feed the hood latch release cable grommet through the dash panel.
2. Apply strip caulk sealer or equivalent around the grommet.
3. Install the hood latch release cable to the hood release handle.

Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

4. Install the bolts to the hood release handle.

Tighten
Tighten the bolts to 5 N·m (44 lb in).

5. Install the nut to the parking brake bracket.

Tighten
Tighten the nut to 5 N·m (44 lb in).

6. Pull the carpet back.



7. Install the hood latch release cable retainers to the engine compartment side rail retainers.
8. Route the hood latch release cable through the radiator support.
9. Install the air cleaner. Refer to the following procedures:

•	Air Cleaner Assembly Replacement in Engine Controls-3.1L

•	Air Cleaner Assembly Replacement in Engine Controls-3.8L

10. Install the front sheet metal diagonal brace. Refer to Front Fender Upper Diagonal Brace Replacement .



11. Install the release cable to the hood latch.
12. If the vehicle is equipped with a supercharger:

•	Install the air intake ducts.

•	Install the push-in retainers to the air intake ducts.

13. Install the left front headlamp. Refer to Headlamp Assembly or Headlamp Bulb Replacement in Lighting Systems.
14. Remove the block from the latch mechanism.
15. Inspect the hood latch for proper operation.
16. Close the hood.