Caution: Refer to Park Brake Cable to Caliper Caution in the Preface section.

Tools Required

J 37043 Parking Brake Cable Release Tool

1. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the right rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.



3. Relieve the park brake cable tension at the equalizer.



4. Disconnect the right rear park brake cable (3) from the clip (2).
5. Disconnect the cable button from the caliper lever.
6. Remove the wheel speed sensor harness clamp from the lower control arm.
7. Remove the right rear park brake cable from the caliper bracket.



8. Use the J 37043 to depress the retaining tabs (1) on the right park brake cable.
9. Remove the right park brake cable from the bracket.

1. Press the right park brake cable into the bracket. Ensure that the locking tabs (1) are properly seated.
2. Install the cable into the caliper bracket.
3. Install the cable end button into the caliper lever.
4. Clamp the wheel speed sensor harness onto lower control arm.



5. Connect the right rear park brake cable (3) to the clip (2).



6. Take up the cable slack at the equalizer.
7. Install the rear tire and wheel assembly. Refer to Tire and Wheel Removal and Installation in Tires and Wheels.
8. Lower the vehicle.
9. Adjust the park brake system. Refer to Park Brake Adjustment .