GM Service Manual Online
For 1990-2009 cars only

Removal Procedure


    Object Number: 1223560  Size: SH
  1. Remove the receiver dryer. Refer to Receiver Dehydrator Replacement .
  2. Remove the Power Steering Pump Drive belt. Refer to Power Steering Pump Belt Replacement in Power Steering System.
  3. Discharge and recover the refrigerant. Refer to Refrigerant Recovery and Recharging .
  4. Remove the bolt securing the low pressure pipe line to the compressor (1).
  5. Remove the bolt securing the high pressure pipe line to the compressor (2).

  6. Object Number: 1223561  Size: SH
  7. Disconnect the electrical connector (2).
  8. Remove the upper bolt mounting the compressor-to-bracket (1).
  9. Remove the lower bolts mounting the compressor-to-bracket (3).
  10. Remove the compressor.

Installation Procedure

    Notice: Refer to Fastener Notice in the Preface section.


    Object Number: 1223563  Size: SH
  1. Install the compressor with the mounting upper (1) and lower (2) bolts.
  2. Tighten

        • Tighten the compressor-to-bracket upper bolt to 20 N·m (15 lb ft).
        • Tighten the compressor-to-bracket lower bolt to 22 N·m (16 lb ft).
  3. Connect the electrical connector.

  4. Object Number: 1223564  Size: SH
  5. Install the A/C high pressure pipe line to the compressor with the bolt (1).
  6. Tighten
    Tighten the A/C high pressure pipe line bolt to 23 N·m (17 lb ft).

  7. Install the A/C low pressure pipe line to the compressor with the bolt (2).
  8. Tighten
    Tighten the A/C low pressure pipe line bolt to 23 N·m (17 lb ft).

  9. Evacuate and charge the system. Refer to Refrigerant Recovery and Recharging .
  10. Install the Power Steering Drive belt. Refer to Power Steering Pump Belt Replacement in Power Steering System.
  11. Install the receiver dryer. Refer to Receiver Dehydrator Replacement .