Notice: Refer to Fastener Notice in the Preface section.

Fastener Tightening Specifications: Refer to Fastener Tightening Specifications .

Preliminary Procedures

1. Open the hood.
2. Remove the air inlet grille panel. Refer to Air Inlet Grille Panel Replacement .
3. Disengage the connector positive assurance (CPA) clip from the wiper motor electrical connector.
4. Disconnect the wiper motor electrical connector from the wiper motor.

1

Bolts, Windshield Washer System Module (Qty: 3)

Tip

1. Install the driver side bolt first.
2. Install the passenger side bolt second.
3. Install the center bolt third.

Tighten
9 N·m (80 lb in)

2

Module Assembly, Windshield Washer System