Callout
| Component Name
|
|
Important: The park brake cable adjusting nut is a nylon lock type. Use ONLY HAND TOOLS whenever tightening or loosening the adjusting nut.
Preliminary Procedures
- Remove the center console. Refer to
Front Floor Console Replacement
.
- With the park brake lever fully released, completely back off the cable adjustment nut.
- Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle
.
- Remove the tire and wheel assemblies. Refer to
Tire and Wheel Removal and Installation
.
|
1
| Park Brake Cable Equalizer
Tip
| • | Carefully position the driveline tunnel insulator downward just enough to access the cable equalizer. |
| • | Rotate the front cable end to release the cable from the equalizer. |
|
2
| Park Brake Cable at the Rear Brake Caliper Cable
Tip
| • | Release the wheel speed sensor harness clips from the park brake cable. |
| • | Disconnect the park brake cables from the park brake actuator levers on the brake calipers. |
|
3
| Park Brake Cable Retainer
|
4
| Park Brake Rear Cable Assembly
Tip
| • | Move the cable conduit rearward to clear the tunnel bracket, then lift the cables to release the cables from the bracket. |
| • | The rear park brake cable is a one piece assembly. |
|
