Step
| Action
| Value(s)
| Yes
| No
|
1
|
- Place the gear selector in Park (automatic transmission) or depress
the clutch pedal (manual transmission).
- Turn the ignition switch to the START position.
- Measure the voltage between the starter solenoid terminal S and
ground.
Is battery voltage measured?
| --
|
Go to Step 8
|
Go to Step 2
|
2
|
- Disconnect the transaxle range switch connector (automatic transmission)
or disconnect the clutch pedal position switch (manual transmission).
- Measure the voltage between the transaxle range switch connector
C2 terminal G and ground (automatic transmission).
- Measure the voltage between the clutch pedal position switch connector
terminal A and ground (manual transmission).
- Turn the ignition switch to the START position.
Is battery voltage measured?
| --
|
Go to Step 3
|
Go to Step 5
|
3
|
- Connect the fused jumper across the transaxle range switch connector
C2 from terminal G of connector C2 to terminal E (automatic transmission)
or across the clutch pedal position switch terminal A and B (manual transmission).
- Turn the ignition switch to START position.
Does the engine crank?
| --
|
Go to Step 4
|
Go to Step 11
|
4
|
- Check the transaxle range switch adjustment (automatic transmission)
or the clutch pedal position switch adjustment (manual transmission).
- If OK, replace the transaxle range switch or the clutch pedal
position switch.
Is the repair complete?
| --
| System
OK
| --
|
5
|
- Disconnect the ignition switch connector C2.
- Measure the voltage between connector C2 terminal C and ground.
Is battery voltage measured?
| --
|
Go to Step 6
|
Go to Step 12
|
6
|
- Reconnect the ignition switch connector C2.
- Turn the ignition switch to the START position.
- Backprobe ignition switch connector C1 and measure voltage with
a DMM between terminal C and ground.
Is battery voltage measured?
| --
|
Go to Step 13
|
Go to Step 7
|
7
| Replace the ignition switch. Refer to Ignition Switch Replacement.
Is the repair complete?
| --
| System
OK
| --
|
8
|
- Place the gear selector in PARK (automatic transmission) or depress
the clutch pedal (manual transmission).
- Turn the ignition switch to the START position.
- Measure the voltage between the starter solenoid terminal S and
the starter motor mounting bolts.
Is battery voltage measured?
| --
|
Go to Step 10
|
Go to Step 9
|
9
|
- Clean the starter motor mounting bolts in order to create a good
ground to the engine block.
- Inspect for rust, dirt or excess paint.
Is the repair complete?
| --
| System
OK
| --
|
10
| Replace the starter
solenoid. Refer to Starter Solenoid Replacement
.
Is the repair complete?
| --
| System
OK
| --
|
11
| Repair the open in
circuit 6 between transaxle range switch or clutch pedal position switch and
starter solenoid.
Is the repair complete?
| --
| System
OK
| --
|
12
| Repair open in the
IGN Fuse or CKT 242 between fuse block and ignition switch.
Is the repair complete?
| --
| System
OK
| --
|
13
| Repair the open in
circuit 5 between ignition switch and transaxle range switch or clutch pedal
position switch.
Is the repair complete?
| --
| System
OK
| --
|
