GM Service Manual Online
For 1990-2009 cars only
Makes 🢒 Pontiac 🢒 1999 🢒 Sunfire 🢒 Engine 🢒 Engine Mechanical - 2.2L 🢒 Engine Mount Strut Bracket Replacement

Removal Procedure

    Caution: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in contact with an exposed electrical terminal. Failure to follow these precautions may result in personal injury and/or damage to the vehicle or its components.

  1. Remove the negative battery cable.
  2. Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle in General Information.
  3. Remove the right splash shield. Refer to Wheelhouse Splash Shield Replacement in Body Front End.
  4. Remove the engine mount strut. Refer to Engine Mount Strut Replacement
  5. Remove the A/C compressor with the lines attached and position it aside.
  6. Remove the transmission brace from the engine.

    7. Object Number: 60506 Size: SH
  7. Remove the engine mount strut bracket bolts.
  8. Remove the engine mount bracket strut.

Installation Procedure

    Object Number: 60506 Size: SH

    Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  1. Install the engine mount strut bracket and the bolts.

    2. Tighten

        • Tighten the front bolts to 66 N·m (49 lb ft).
        • Tighten the rear bolts to 66 N·m (44 lb ft).
  2. Install the transmission brace to the engine.
  3. Install the A/C compressor. Refer to Air Conditioning Compressor Replacement in HVAC Systems with A/C - Manual.
  4. Install the engine mount strut. Refer to Engine Mount Replacement .
  5. Install the right splash shield. Refer to Wheelhouse Splash Shield Replacement in Body Front End.
  6. Lower the vehicle.
  7. Connect the negative battery cable.

    8. Tighten
    Tighten the bolts to 16 N·m (12 lb ft).