Tools Required

J 41239-10 Cooler Pipe Seal Remover

1. Raise the vehicle. Support the vehicle . Refer to Lifting and Jacking the Vehicle in General Information.
2. Remove the transmission oil cooler lines from the transmission. Refer to Automatic Transmission Oil Cooler Pipes Replacement .



3. Remove the oil cooler line seals.



4. Remove the cooler line bracket stud.

Tools Required:

J 41239-1A Cooler Pipe Seal Installer

1. Install the J 41239-1A on the transmission case using cooler line bracket stud hole.
2. Install a new seal in the case bore.
3. Press the new seals in. Tighten the cooler line bracket bolt until the seal bottoms out in the case bore.



4. Install the cooler line bracket stud.
5. Install the transmission oil cooler lines. Refer to Automatic Transmission Oil Cooler Pipes Replacement .
6. Lower the vehicle.
7. Inspect the transmission fluid level. Refer to Transmission Fluid Check .