GM Service Manual Online
For 1990-2009 cars only

Removal Procedure

  1. Remove the front inner wheel housing. Refer to Wheelhouse Splash Shield Replacement in Body Front End.
  2. Remove the park/turn signal lamp retaining nuts.
  3. Push the lamp assembly outward.
  4. Disconnect the electrical connector.

  5. Object Number: 280062  Size: SH
  6. Remove the socket by completing the following steps:
  7. 5.1. Depress the locking tab.
    5.2. Rotate the socket (3) counter-clockwise.
  8. Remove the bulb from the socket (3).

Installation Procedure


    Object Number: 280062  Size: SH
  1. Install the bulb to the socket (3).
  2. Install the socket (3) into the park/turn signal lamp assembly.
  3. Turn the socket (3) counterclockwise.

  4. Connec the electrical connector.
  5. Install the park/turn signal lamp.
  6. Notice: Use the correct fastener in the correct location. Replacement fasteners must be the correct part number for that application. Fasteners requiring replacement or fasteners requiring the use of thread locking compound or sealant are identified in the service procedure. Do not use paints, lubricants, or corrosion inhibitors on fasteners or fastener joint surfaces unless specified. These coatings affect fastener torque and joint clamping force and may damage the fastener. Use the correct tightening sequence and specifications when installing fasteners in order to avoid damage to parts and systems.

  7. Install the park/turn signal lamp retaining screws.
  8. Tighten
    Tighten the screws to 2 N·m (18 lb in).

  9. Install the front inner wheel housing. Refer to Wheelhouse Splash Shield Replacement .