1

1. Sit in the driver's seat.
2. Close the door.
3. Turn the ignition switch to the RUN position.
4. Unbuckle the driver's seat belt.

The fasten belts chime sounds for 4 to 8 seconds.

2

1. Sit in the driver's seat.
2. Close the door.
3. Turn the ignition switch to the RUN position.
4. Unbuckle the driver's seat belt.
5. Buckle the driver's seat belt.

3

1. Turn the ignition switch to the OFF position.
2. Leave the key in the ignition switch lock cylinder.
3. Open the driver's door.

The key-in-ignition chime sounds at an initial rate of 6 to 9 tones in 3 to 4 seconds. This rate is faster than the seat belt chime. After the initial warning, the chimes sound at the rate of once every 3 to 4 seconds.

4

Remove the ignition key from the ignition switch.

The chime stops.

5

1. Turn the ignition switch to the OFF position.
2. Turn the headlamp switch to the PARK position.
3. Open the driver's door.

The lights-on chime sounds at the rate of 5 tones per second. This rate is faster than the key-in-ignition chime.

6

Turn the headlamp switch to the OFF position.

The chime stops.

7

Open the right front door.

The interior lights illuminate.

8

Power Output Diagnostic Mode. The following actions verify the operation of the following components:

1. Close the front doors.
2. Set the park brake.
3. Turn the ignition switch to the RUN position. Before 15 seconds pass, perform the following steps:

3.1.	Open the right front door.

3.2.	Cycle the headlamp switch from the OFF position to the PARK position 3 times.

The interior lamps flash until you turn the ignition switch to the OFF position. The multi-function alarm module returns to normal operation.